| 1. To remove a weight wire from the accumulator. |
| 2. To weaken and take off a driving belt of the generator. |
| 3. To remove casings of a driving belt of the camshaft. |
| 4. By means of a bolt of a pulley to turn a bent shaft so that to establish elements of the drive of gas distribution in the situation allowing to record them cores. |
|
5. To weaken a tension of a gear belt and, if necessary, to remove the belt tension mechanism (in the drawing the automatic mechanism of a tension for models 1580 of cm3 and 1905 cm3 with 8 valves is represented). |
| 6. To remove the blocking cores from pulleys, to take off a gear belt. |
|
7. To unscrew a bolt of fastening of a pulley of the camshaft, holding a pulley from a provorachivaniye the special tool and to remove a pulley. To check for tightness (on existence of smudges) forward consolidation of the camshaft. |
| 8. To unscrew a bolt of fastening of a pulley of a bent shaft, at the same time to hold a pulley from a provorachivaniye, having recorded an engine flywheel and to remove a pulley together with a spline. If the engine is installed in the car, it is possible to record a bent shaft from a provorachivaniye, having included the 4th transfer and having pressed a brake pedal. To check for tightness (on existence of smudges) forward consolidation of a bent shaft. |
| 9. Installation of pulleys is made in the sequence, the return to removal then it is necessary to make adjustment of a tension of a gear belt. |
