1. To install adaptation of blocking of a flywheel (Facom D 86) and to tighten a bolt of fastening of a pulley of a bent shaft the moment of 110 Nanometers. |
2. To take adaptation of blocking of a flywheel. |
3. To establish the top casing of a belt. |
4. To establish and pull a driving belt of the generator. |
5. To start the engine which has to work before turning on of the fan, and then wait until it cools down (at least, two hours at an open cowl). |
6. To install the cylinder 1 piston in VMT. The sign on a flywheel has to be opposite to the sign "0" on an adjusting plate of ignition, and the opening for a core in a pulley has to be in the situation corresponding to two hours on the dial of hours. |
7. To weaken and tighten nuts of the holder of a tension roller and the clown's lock-nut. |
8. To install adaptation of blocking of a flywheel. |
9. To take off a driving belt of the generator. |
10. To establish plastic a casing: the lower right, top, lower left. |
11. To establish a pulley and to tighten bolts the moment of 110 Nanometers. |
12. To take adaptation of blocking of a flywheel. |
13. To establish the lower leaf closing a coupling case. |
14. To establish and pull a driving belt of the generator. |
15. To establish a side casing. |