e8879fe5

3.4.1.3. Removal and installation of the distributor of ignition

Removal

PERFORMANCE ORDER
1. To improve access to the ignition distributor, previously to remove the ignition coil.
2. To remove a protective waterproof cover from the ignition distributor.
3. To unscrew screws of fastening of the distributor of ignition.
4. To uncover the ignition distributor.
5. If necessary to remove high-voltage wires from a cover and spark plugs.
6. To disconnect the pipeline of the vacuum regulator.
7. To disconnect the socket from the electronic module.
8. To note mutual position of the case of the distributor and a head of the block of cylinders (shooters specified tags of installation of the moment of ignition).
9. To displace grooves on distributive to a shaft for an ignition distributor drive lead.
10. To remove elements of fastening of the distributor and to take the distributor.

Installation

PERFORMANCE ORDER
1. To check and, if necessary, to replace a round sealing ring on the landing end of the distributor.
2. To install the distributor, turning a rotor so that it is correct to arrange a drive lead (only one situation).
3. To screw in bolts of fastening of the distributor.
4. To establish a distributor rotor.
5. To establish and fix a distributor cover.
6. To connect wires.
7. To adjust an ignition advancing corner (see subsection 3.4.1.6).