4.2.6. Elements of system of injection Fenix
SENSOR OF PROVISION OF THE BUTTERFLY VALVE
Removal
| PERFORMANCE ORDER |
| 1. To remove a weight wire from the accumulator and contact of a wire from the sensor. |
| 2. To unscrew two screws and to take the sensor. |
|
FUEL NOZZLE
Removal and installation
| PERFORMANCE ORDER |
| 1. To take off pressure in fuel system. |
| 2. To remove a weight wire from the accumulator. |
| 3. To unscrew two bolts of fastening and to uncover the air filter. |
| 4. To remove a bracket of fixing and a wire from contact of a nozzle. |
| 5. To unscrew the fastening screw, to lift a clamp and to take a nozzle. |
| 6. At installation it is obligatory to replace a sealing ring. |
|
ADJUSTING VALVE OF TURNS OF IDLING
Removal
| PERFORMANCE ORDER |
| 1. To remove a weight wire from the accumulator. |
| 2. To remove contact of a wire from the valve. |
| 3. To weaken clips and to remove two air hoses from the valve basis, noting their locations concerning the direction of the stream noted on the valve case. |
| 4. To weaken two nuts and to take the valve. |
|
PRESSURE REGULATOR
The regulator of pressure is screwed by four screws on an injector.
THE SENSOR OF TEMPERATURE OF THE SOAKED-UP AIR
The sensor is screwed in above in a final collector.
Removal
| PERFORMANCE ORDER |
| 1. To remove a weight wire from the accumulator. |
| 2. To remove contact of a wire from the sensor. |
| 3. To unscrew the sensor and to remove it. |
|
PRESSURE SENSOR IN THE INLET COLLECTOR
The sensor is installed on a forward part.
Removal
| PERFORMANCE ORDER |
| 1. To remove a weight wire from the accumulator. |
| 2. To remove contact of a wire from the sensor. |
| 3. To remove a vacuum hose from the sensor. |
| 4. To unscrew two bolts of fastening and to remove the sensor. |
|
SENSOR OF TEMPERATURE OF COOLING LIQUID
Removal
| PERFORMANCE ORDER |
| 1. To disconnect the electric socket from the sensor. |
| 2. To merge the cooling system. |
| 3. To unscrew the sensor. |
|
SENSOR OF SITUATION AND FREQUENCY OF ROTATION OF THE ENGINE
Removal
| PERFORMANCE ORDER |
| 1. To remove wires from fastening brackets. |
| 2. To unscrew a bolt and to take the sensor from the engine. |
|
