14:18. Radio receiver
THE RADIO RECEIVER WITH DIN CLAMPS
Removal
| PERFORMANCE ORDER |
| 1. To disconnect a negative wire from the accumulator. |
|
2. To remove plastic caps from two parties of the radio receiver. |
|
3. Removal of the radio receiver requires two special U-shaped tools. To insert two special U-shaped tools on the right and at the left into openings of the forward panel of the radio receiver. |
| 4. To slightly wring out the special tool outside at the expense of what brackets of fastening nestle inside. |
| 5. In this situation to extend the radio receiver by uniform effort. At a pulling not to warp the radio receiver. |
| 6. To mark and disconnect sockets and the plug of the antenna. |
| 7. To remove strippers for what to squeeze fastenings by the small screw-driver. |
|
8. To remove the radio receiver. |
|
Installation
Installation is made in the sequence, the return to removal.
THE RADIO RECEIVER WITH "PEUGEOT" CLAMPS
Removal
| PERFORMANCE ORDER |
| 1. To disconnect a negative wire from the accumulator. |
| 2. To open the cover closing the radio receiver. |
|
3. To remove a finishing plate over the radio receiver for access to two openings in which tools for removal of the radio receiver are installed. |
| 4. For extraction of the radio receiver it is necessary to use the special tool or two cores with flutes on the end which connect to fastening brackets. |
|
5. To insert the special tool (it is specified by an arrow) or two cores with flutes on the end into openings in the top part of the radio receiver before their connection with brackets of fastening and to release brackets of fastening of the radio receiver. |
|
6. Using tools, to extend the radio receiver by uniform effort. At a pulling not to warp the radio receiver. |
|
Installation
Installation is made in the sequence, the return to removal.
