9.1. Technical characteristic

Transfer of draft on wheels is provided by two power shafts of different length. Each shaft has two hinges. From the transmission the three-humeral JB 2 hinge is installed, and from a wheel – the spherical hinge.

Inhaling moments

Wheel nave nut
265 Nanometer
Bolt of the bearing of the intermediate bearing case
17,5 Nanometer
Nut of the spherical hinge of a suspension bracket
30 Nanometer
Wheel bolts
85 Nanometer


Privodnoy Bridge with electromagnetic blocking.

Type: PC7.


Amount of oil
1,6 dm3
The recommended type
Esso Gear Oil BT 80W/90 or Shell Gear TT 80W/90
Frequency of replacement
through 1500 – 2000 km, and then through each 20 000 km of a run

Power shaft

The power shaft consists of two shaft, krestovinny hinges on the ends and the hinge in the middle.

Brand: Glaenzer.


Replacement only of the intermediate bearing is admissible. It is necessary to observe alignment of axes of forward and back shaft at their designation before dismantling.

Each power shaft has two identical hinges with right and on the left side.

The hinge from a wheel: the Rzeppa type with balls of 16 mm.

Tightening moments

Fastening of a nave to the lever
60 Nanometer
Bolts of a flange of a power shaft on forward and back connectors
20 Nanometer
Fastening of a flange of the bearing to a body
20 Nanometer
Forward arm of the driving bridge
50 Nanometer
Back arm of the driving bridge
45 Nanometer