8.2.9. Removal and installation of the operating servomotor

Arrangement of bolts of fastening of the operating servomotor

Bolts of fastening are specified by shooters.


1. To merge oil from the automatic transmission.
2. To remove the oil pallet.
3. To hold a pedal of an accelerator of the pedal (adaptation 0204) pressed by means of the special device for pressing.
4. To unscrew 10 bolts of fastening of the operating servomotor and to remove it.

Installation of the operating servomotor


1. In the car to install the gear shifting lever in situation "1".
2. On the automatic transmission:
      – to check whether are established sector (1) and (2) so that surfaces (A) and (In) were at one level;
      – to check whether the shaft (3) and a cam (4) hold the correct position (when pressing a pedal in the car).
3. On the operating servomotor:
      – to press the ram (5) and the piston (6) in a nest.
4. To install the operating servomotor on the automatic transmission and to check whether the ledge (7) entered a clip (8) of the ram (5) and whether the end of an axis (9) entered an opening (10).
5. To screw in bolts of fastening of the operating servomotor (shorter – "With", longer – "D") and to tighten them the corresponding moments.
6. To install the oil pallet.
7. In the car to take the special device for pressing of a pedal of an accelerator.
8. To fill in oil in the automatic transmission to necessary level.