e8879fe5

8.2.7. Cable of compulsory inclusion of a low gear

Measurement of distance (X) between a ledge on a cable of compulsory inclusion of a low gear and the carving end of a cover of a cable

1 – cable of compulsory inclusion of a low gear

Measurement of a gap (b) between a ledge on a cable of compulsory inclusion of a low gear and the carving end of a cover of a cable and nut for adjustment of a gap

1 – a nut for adjustment of a gap

Adjustment of a cable of compulsory inclusion of a low gear has to be made on the heated-up engine.

Adjustment
PERFORMANCE ORDER
1. To check and if necessary to adjust idling turns.
2. To switch off the engine and to check adjustment of a cable of an accelerator. To disconnect a cable of compulsory inclusion of a low gear from the lever on the carburetor or the case of throttles and again to check adjustment of a cable of an accelerator.
3. To extend a cable of compulsory inclusion of a low gear from a cover and to measure distance between a ledge on a cable and the carving end of a cover of a cable which has to make 39,0 mm. If the measured size is not equal to 39,0 mm, to unscrew two lock-nuts of fixing of a cover of a cable and moving nuts on a cover of a cable to establish the required distance (see rice. Measurement of distance (X) between a ledge on a cable of compulsory inclusion of a low gear and the carving end of a cover of a cable).
4. To repeatedly connect a cable of compulsory inclusion of a low gear to the carburetor or the lever on the case of throttles and to check a gap between a ledge on a cable and the carving end of a cover of a cable which has to make 0,5 mm. If the measured size is not equal to 0,5 mm, to unscrew two lock-nuts of fixing of a cover of a cable and moving nuts on a cover of a cable to establish the required distance (see rice. Measurement of a gap (b) between a ledge on a cable of compulsory inclusion of a low gear and the carving end of a cover of a cable and nut for adjustment of a gap).