e8879fe5

4.3.10. Inlet collector

Use of sealant at installation of a collector


To check existence of the directing probes at installation of a collector

The directing probe is specified by an arrow.

Installation of an inlet collector


Screwing up of bolts of fastening of a collector


BOSCH L3 SYSTEM. L (JETRONIC)

Removal

PERFORMANCE ORDER
1. To remove the fuel highway, without disconnecting hoses.
2. To remove a vacuum hose of the amplifier of brakes.
3. To remove the case of throttles.  
4. To remove ignition coils.  
5. To remove an additional air hose of an air inlet from a collector.
6. To unscrew a bolt from a starter suspension bracket.
7. To unscrew a bolt of support of an oil pipe.
8. To unscrew bolts of fastening of a collector and two bolts of 5 mm. Unscrewing of bolts of 5 mm requires a long key.
9. To remove a collector.

BOSCH LU2-JETRONIC, MOTRONIC AND MAGNETI MAREILLI SYSTEMS

Removal

PERFORMANCE ORDER
The procedure of removal of a collector is similar described above, considering the next moments:
      – vacuum hoses and a hose of cooling liquid and an electrical wiring change depending on model. At separation of any pipes, hoses, or wires, take their location into account to guarantee the correct installation on the former place;
      – ignore references on a zabornik of air and a starter suspension bracket;
      – any removed laying needs to be replaced.