188.8.131.52. Removal of a head of the block of cylinders
This operation demands partial removal of a gear belt.
| PERFORMANCE ORDER
| 1. Fix the right top support of the engine, and then take adaptation of support of the engine (it does not concern the THAT XUD 7 engine).
|2. Remove the air filter, and also its connections, pipelines of injection and a cover of a head of the block of cylinders.
| 3. Disconnect branch pipes of cooling liquid, fuel pipelines, electric connections from a head of the block of cylinders. Disconnect the draft of idling strengthened on the pump with the increased speed.
|4. In the THAT XUD 7 engine incline the engine forward and insert wooden whetstone (see rice. Placement of wooden whetstone for fixing of the engine). Remove an inlet collector (the central screw of fastening).
|5. Take off a belt of the drive of the pump of the amplifier of steering (if the car is equipped with steering with the amplifier).
|6. Remove the left eye for raising of the engine.
|7. In the XUD 9 engine disconnect a final tube about a collector and take it from a broad tank.
|8. Unscrew a bolt of fastening of a pulley to the camshaft, unscrew the blocking bolt and remove the cogged pulley.
|9. Put the clamp of an axis of a tension roller and unscrew the top bolt.
|10. Unscrew a bolt of fastening of an arm of the engine to a head of the block of cylinders.
|11. In the THAT XUD 7 engine unscrew three bolts of fastening of a turbocompressor to a final collector.
|12. Unscrew ten bolts of fastening of a head of the block of cylinders "on a spiral", beginning from an external bolt, and take them together with washers.
|13. Separate a head of the block of cylinders and remove, directing it to the right side so that to take the end of the camshaft from a camshaft case opening. The bracket of fastening of a bypass branch pipe (on the right side of the engine) should be protected rags in order to avoid damage of a surface of connection during removal of a head of the block of cylinders.