14:23. Safety cushion elements
Safety cushion sensors compound with the electronic control device which is independently compound with a steering wheel. A lamp of the alarm system of a safety cushion compound with safety cushion unit.
ELECTRONIC CONTROL DEVICE OF THE SAFETY CUSHION
The electronic control device of a safety cushion compound with a steering wheel can be also removed only with a steering wheel.
SAFETY CUSHION
Safety cushion – an integral part of a steering wheel.
Removal
PERFORMANCE ORDER |
1. Before performance of any actions on a security system to remove the negative plug from the accumulator and to wait, at least, 10 minutes. |
|
2. To unscrew two screws (are specified by shooters) the fastenings of a safety cushion located from a back part of a steering wheel. For access to screws to turn a steering wheel. |
3. To disconnect the electric socket from a safety cushion. |
|
Installation
PERFORMANCE ORDER |
1. Installation is made in the sequence, the return to removal. At the same time it is necessary to consider the next moments. |
2. Not to strike a safety cushion or to subject to collisions in the course of installation on the former place. |
3. To tighten screws of fastening of a safety cushion the required moment. |
4. In conclusion to make active system of a safety cushion for what to perform the following operations. |
5. To close car doors, at the same time in the car there should not be people. |
6. To include ignition. |
7. To connect a weight wire to the accumulator. |
8. To switch off ignition. |
9. To repeatedly include ignition and to check that the lamp of the alarm system of a safety cushion on a steering wheel burns three seconds then dies away. |
10. To include ignition. |
|
ROTARY CONNECTOR OF THE SAFETY CUSHION
Rotary connector of a safety cushion
|
1 – rotary connector,
2 – electric socket,
3 – brackets of fastening of a rotary connector |
Removal
PERFORMANCE ORDER |
1. To remove a safety cushion. |
2. To remove a steering wheel. |
3. To unscrew screws of fastening and to remove the lower casing of a steering column. |
4. To remove the top casing of a steering column. |
5. To disconnect the electric socket from a rotary connector. |
6. Using the screw-driver, to release three brackets of fastening and to remove a rotary connector. |
|
Installation
PERFORMANCE ORDER |
1. Installation is made in the sequence, the return to removal. At the same time it is necessary to consider the next moments. |
2. Before installation to check for the former place of casings of a steering column and safety cushion that the plait of wires was laid correctly and, moving a steering wheel that the electrical wiring does not cling to anything. |
3. To establish a steering wheel. |
4. To establish a safety cushion, but not to make active a safety cushion at this stage. |
5. In conclusion to move a steering column to the lifted situation, then to check that the gap between a back part of a steering wheel and casings of a steering column was 8,0 mm. If the gap differs from demanded, to perform the following operations. |
6. To turn off a carpet about pedals for access to a coupling bolt of a steering column. |
7. To weaken a coupling bolt and to move a steering shaft before receiving a gap between a back part of a steering wheel and casings of a steering column of equal 8,0 mm. |
8. To tighten a coupling bolt and to establish into place a carpet. |
9. To make active a safety cushion. |
|