e8879fe5

11.1.4. The lobby is resistant

Removal

PERFORMANCE ORDER
Prevention

All nuts of Nyloc unscrewed at removal need to be replaced with new. The carving of these nuts is covered by structure against unscrewing which is effective only at the first use of a nut.
1. To lift a forward part of the car and to record on supports. To remove the corresponding forward wheel.
2. In a motor compartment to remove a protective plastic cap from the top part of a forward rack. To unscrew, but not completely, two nuts of the top fastening of a forward rack (are specified by shooters).
3. To disconnect electric wires and hoses from a rack.
4. To unscrew a bolt of fastening of a connector of the stabilizer of cross resistance to a rack and to separate a connector from a rack.
5. To unscrew a nut and to take tightening a bolt of fastening are resistant to a rotary fist. For prevention of lowering of a rotary fist with a nave, at removal of a rack to tie a wire the lower lever or a nave to the lower frame.
6. For investment of removal of a rotary fist from a rack to install the device for compression of springs and to slightly squeeze springs.
7. To insert the lever into a groove in rotary a fist and to expand a groove so that it was possible to remove a rotary fist from a rack.
8. To remove a rotary fist from a rack, then to finally unscrew two nuts of the top fastening of a rack and to take a rack from under a wheel arch.

Installation

PERFORMANCE ORDER
1. To establish a forward rack into place so that the adjusting pin of a plate of the top fastening correctly settled down in the corresponding opening. To combine the lower end of a rack with a rotary fist. At the same time it is necessary to combine a crack in a clip of a rotary fist with a ledge on the end of a rack.
2. To check that the lower part of a rack is precisely combined with a rotary fist. To insert tightening a bolt from the back party of the car and to fix it by a new nut.
3. To screw a connector of the stabilizer of cross resistance to a rack.
4. To screw the top nuts of fastening of a rack and to tighten them the required moment.
5. To weaken and then to remove the device for compression of springs.
6. To fix electric wires and hoses on a rack arm.
7. To establish a wheel and to lower the car.